Clixe BMW 1 | Airbag Emulator with Connector

Check the correct operation of the Airbag system in:

BMW (year 2007 - 2010)

Series 1: E81

3 Series: E90, E92, E93

5 Series: E60, E63, E64

Series 7: E65

X Series: E70, E71

The emulator is sold with resistors to emulate the seat belt signal

Attention: If, even after the installation of the emulator, your car indicates a failure of the unfastened passenger seat belt, place a resitor in place of the seat belt sensor.

For E90, use a 680 ohm resistor For E60, use a 510 ohm resistor

This emulator can only be used for testing purposes or to verify the correct functioning of the AirBag system. This emulator cannot remain in your car as a replacement for the new seat occupancy mat.

Please note: the use of emulators is for testing/diagnostic purposes. The purchase of this device is a personal decision and our company is not responsible for any legal problems that arise with this decision if it is not used according to the stated purpose of testing/diagnosis.

For the installation of emulators, in many cases programming and diagnostic equipment and advanced knowledge of electronics are needed, if you are not qualified, please do not buy it and ask for the installation from a professional.

Support is included by the emulator manufacturer itself, as well as installation manuals if necessary.