Kefico Sim2K-510 SCR + DPF Emulator

This emulator fully simulates SCR and DPF systems.

If your DPF filter is damaged or if you personally want to remove an intact filter, you can disable the DPF filter by connecting all cables. If your DPF filter is intact and you do not want to remove it, you can connect only the green-yellow CAN-BUS lines and the red-black voltage lines as described in the document to perform only the SCR system simulation. In this type of connection, regeneration is not necessary and your DPF filter will not clog.

Installation Manual

Note: The casing and labeling of this product are handmade using 3D printing. Due to this process, they may have small aesthetic imperfections. However, this does not affect its functionality at all.

Please note: the use of the emulator is for testing/diagnostic purposes. The purchase of this device is a personal decision and our company is not responsible for any legal problems that arise with this decision if it is not used according to the stated purpose of testing/diagnosis.

For the installation of emulators, in many cases you need programming equipment and advanced knowledge of electronics, consult the installation manuals and/or instructions on the website, and if you do not feel qualified, please do not buy it and ask for the installation from a professional.

The use of this device causes a higher emission of exhaust gases. When you start using the emulator, your vehicle will not comply with Euro 4, Euro 5 and Euro 6 standards. Our device is intended for countries that do not have Euro 4/5/6 ecological standards. The use of these devices is for troubleshooting or for use in countries that do not have Euro 4/5/6 ecological standards.